I Will Be At Technical University in Atlanta

IBM Tech U Atlanta 2019


This is just a quick post to say that I will be at IBM Technical University in Atlanta. I will be there from April 29 through May 3

My sessions for this event are:
  • s106417 The Path of an FC Frame Through a Cisco MDS Director
  • s106420 Proactive Monitoring of a Cisco Fabric
  • s106421 Troubleshooting Cisco SAN Performance Issues - Part 1
  • s106422 Troubleshooting Cisco SAN Performance Issues - Part 2
Find these sessions and many more at Technical University. Click the banner at the top of the page to register or for more information.

As always, if you have any questions, leave them in the comments at the end of this blog or find me on LinkedIn or Twitter.

Comments

Post a Comment

Popular posts from this blog

Image
Troubleshooting CRC Errors On Fibre-channel Fabrics There is no "Easy Button" for troubleshooting CRC errors. It is an iterative process. You make a change, you monitor your fabric, and if necessary you make more changes until the issues are resolved. I frequently have customers who want it to be a one step process. It can be, but usually takes multiple steps. Having said that, before we can fix them, we need to know what CRC errors are and why they occur. What Are CRC Errors? When Do they Occur? The simple answer is that CRC errors are damaged frames. The more complicated answer is that before a fibre-channel frame is sent, some math is done. The answer is added to the frame footer. When the receiver gets the frame, the receiver repeats the math. If the receiver gets a different answer then what's recorded in the frame, then the frame was changed in flight. This is a CRC error. The only time these happen is if the physical plant - cabling, SFPs is somehow...
Read more

Troubleshooting Slow Drain Devices on Broadcom Switches

Image
  Slow drain devices are one of the more common problems on storage networks.  They can occur for a variety of reasons.  For a refresher on how they can affect your storage network you should watch  this video .    In this blog post I will go through the basic steps to troubleshoot a slow drain device on a Broadcom fabric.    I will be using command line output from switches.  The CLI format lends itself better to a blog post more readily than screen shots from a GUI, and the commands are consistent across different versions of FOS.    SANnav is a huge change from Brocade or IBM Network Advisor and the screens would look quite different between the two. The first command we will be using is porterrshow.    The above output has been truncated for the ports we are interested in. The counters of interest are in the c3timeout column.  You can see that there are 2 sub-columns, 'tx and 'rx'.   'tx' means the switc...
Read more

Spectrum Virtualize NPIV and Host Connectivity

Image
 A while ago I wrote  this post  as an introduction to the Spectrum Virtualize NPIV feature.  In this follow-up post I thought I would focus more on host connectivity and the effects of NPIV.    You can watch a quick review of the NPIV feature in this IBM Systems Rockstar video:      NPIV has 3 modes: 1.  Disabled - this mode means that hosts cannot connect to the virtual World Wide Port Names  (WWPNs) on the Spectrum Virtualize cluster, regardless of the fabric zoning 2.  Transitional - this mode means hosts can connect to either the physical or virtual WWPNs on the cluster.  If a host is zoned to both, it will connect to both.   Transitional mode is meant to only be used while you are migrating to NPIV mode and rezoning your hosts to the virtual WWPNs.  It is not meant to be used permanently or even long-term.   3.  Enabled - this means hosts can only connect to the virtual WWPNs. ...
Read more